09.08.2010 G081PU312W.doc 1 of 4 G081PU312W technical data high power fiber coupled infrared laser diode specifications (25c) type G081PU312W unit optical specification cw output power from fiber p f 12 w center wavelength c 808 nm wavelength tolerance 800 ? 820 nm spectral width ? < 7 (4) nm wavelength temperature coefficient 0.3 nm/c fiber characteristics fiber core size 700 m n.a. 0.12 fiber length 1 m connector fc/st/sma-905 electrical specification slope efficiency e s > 12 w/a threshold current i th 250 ma operation current i o 1250 ma operation voltage v f < 35 v series resistance r d < 3.5 ? package style p3-package absolute maximum ratings reverse voltage v r 35 v operating temperature t o -10 ? 45 c storage temperature t stg -40 ? 85 c features ? cw output power: 12 w ? typical 808 nm emission wavelength ? high reliability ? high efficiency applications ? laser pumping ? medical usage ? printing ? heating ? material dealing ? marking
09.08.2010 G081PU312W.doc 2 of 4 package dimensons p3-package ( unit:mm )
09.08.2010 G081PU312W.doc 3 of 4 typical performance curves
09.08.2010 G081PU312W.doc 4 of 4 notes 1. laser beam is harmful especially for your ey es. don't look at the laser beam directly. 2. lifetime of the diode laser variated with the operating temperature inversely. we advise that the tec cooler should be used to keep the temperature suitable. 3. for turning on the diode laser, please increase the current gradually to the specified operating value. for shutting down the diode laser, please decrease the current to zero gradually, and then turn off the power. 4. please wear staticproof bracelet when operating. 5. please connect the pins of the diode laser correctly as the picture showen in the manual. 6. the operating current must less than the rated current. otherelse the diode laser should be damaged. 7. the fiber facet should be keep clean befor the diode laser is operating. 8. please use the constant-current source to avoid the surge. 9. diode laser should be short circuit when stop using. 10. bend diameter of the fiber must be la rger than 4cm temporarily and 8cm permanently.
|
